2006 lexus gs300 rear window shade control

Refer to Windshield Pillar Garnish Molding Replacement. Remove the windshield side garnish molding.Refer to Roof Side Rail Lamp Replacement in Lighting. Refer to Sunroof Seal/Molding Replacement in Roof. Remove the sunroof trim lace, if equipped.Refer to Sunroof Switch Replacement in Roof. Remove the power sunroof switch, if equipped.Remove the overhead console, if equipped.J 38778 Door Trim Pad and Garnish Clip Remover Refer to Headlining Trim Panel Replacement in Interior trim. Place the sunroof module in the fully closed position. Remove the sunroof window from the module. Remove the sunroof screws (two on each side). Move the sunroof window to the vent position. Refer to Sunroof Glass Panel Replacement. Anytime the actuator needs to be removed from the module, ensure that the sunroof window is in the fully closed position. This may cause the timing to be thrown off. Use extreme care when removing the actuator from the sunroof module. Important: This sunroof system is timed from the factory in order to allow the actuator to shut off automatically when the sunroof window reaches a certain position. The wire is the power connection for the vanity light located within the visor. There will be a wire attached that has a plastic male/female connection that can be pulled apart. You unscrew the two bolts and gently take the visor off the mount. IF THE VEHICLE IS EQUIPPED WITH LIGHTED SUNSHADES REMOVE THE ELECTRICAL CONNECTORS FROM THE HEADLINER Take off the two front plastic pieces located at the front of the rails and slide the cross bars off. REMOVE THE INBOARD RETAINER FROM THE HEADLINER.ġ2. IN ORDER TO REMOVE THESUNSHADE FROM THE HEADLINER, CAREFULLY GRAB THE HEADLINER AT THE WINDSHEILD PILLAR AREA AND APPLY DOWNARD PRESSURE WHILE GENTLY ROCKING THE SUNSHADE UP AND DOWN.ġ1. YOU WILL NOTICE A SEPARATION BETWEEN THE HEADLINER AND THE SUNSHADE BEZEL.ĩ. PULL THE SUNSHADE DOWNARD WHILE MAINTAINING OUTBOARD PRESSURE TO THE SUNSHADE. APPLY OUTBOARD PRESSURE TO THE SUNSHADE WHILE THE SUNSHADE IS PARALLEL TO THE WINDSHEILD.Ĩ. THE SUNSHADE PIVOT ARM BEZEL SHOULD APPEAR TO BE RECESSED INTO THE BEZEL.ħ. THE SUNSHADE PARALLELL TO THE WINDSHEILD. INSERT A SMALL TOOL INTO THE BEZEL ACCESS HOLE. OPEN AND ROTATE THE SUNSHADE PARALLEL TO THE SIDE WINDOW.ĥ. RELEASE THE UPPER PORTION OF THE CENTER PILLAR TRIM PANEL THEN PRESS THE END OF THE HANDLE OUTWARD AND PULL IT SHOULD RELEASE.)ģ. SCREW DRIVER AND PRESS THE CLIP TOWARDS THE INSIDE OF THE HANDLE. (TO DO THIS YOU MUST POP OFF THE COVER ON EITHER SIDE AND YOU WILL SEE A RETAINER CLIP ON THE OUTER EDGES OF EITHER SIDE. RELEASE THE FRONT ASSIST HANDLE FROM THE HEADLINER.

2006 lexus gs300 rear window shade control